waterfigure_9892 (by Frans)
waterfigure_9892
Colored waterfigures. Tools used are a homemade hardware controller with an Altera FPGA chip (DE1 terasic board) 2 lasers are used for the detection. Multiple flashes are used. The controller calculate the delay timings, power for the waves on the speaker, camera control and flashes.See also:
fotoopa.smugmug.comUpdate:
How to make this picture:Lower part is the membrane on top of a speaker. Before the special waveform is applied a soapbubble is placed above a few colored waterdrops. At this point you have the membrane, color liquids and the soapbubble. The “ball” is a marble that fall and pass through a laserbeam. A photodiode give a signal to the controller to start all the timings needed. The waveform signal is applied after a time and that forms the waterfigures. But at the same time the marble falls into the soapbubble. At this moment its time to fire all the flashes. Ofcource the camera need to be actief at the right time to to have the correct picture. All this correct settings timings and delays give nice figures.
fotoopa.
Whoa.
I see Krypton’s red sun crashing into the bottle city of Kandor.
And I hate my brain because this scenario is non-canonical.
(I may have issues.)
(via kurafire)
Source: Flickr / fotoopa_hs
15 Notes/ Hide
- chrismear liked this
- wolfidy-blog liked this
- onesmallfire liked this
- smartasshat reblogged this from kurafire
- mickhd-blog liked this
- redcloud liked this
- aggastyantamas liked this
- froggeek liked this
- felistella-blog liked this
- kurafire reblogged this from timoni and added:
Whoa.
- kurafire liked this
- pappito reblogged this from timoni
- vikiview reblogged this from timoni
- timoni posted this